+86-533-6286577

Installation Method And Construction Steps Of Ceramic Fiber Board

Sep 30, 2021

In order to maximize the thermal insulation functions of the ceramic fiber board , today SUNTHERM introduces the correct installation method and construction steps of the ceramic fiber board:

1. clean up the residua floating ash, oil and other debris and empty drum parts of ceramic fiber felt left on the concrete wall.

2. Remove concrete blocks, inclusions, hollows, etc. caused by roof splitting, and repair them again.

3. It is required to paste the ceramic fiber cotton with the surface flatness deviation of ceramic fiber board no more than 4 mm. If the deviation is out of tolerance, the protruding concrete surface shall be polished, and the recessed part shall be patched (1: 2.5 cement mortar shall be used for plastering when the thickness is more than 6mm, and polymer bonding mortar shall be used for patching when the thickness is less than 6mm); To ensure the flatness of the whole wall within 4mm, the angle of yin and yang is square and smooth from top to bottom.

4. Mortar used in construction is divided into special bonding mortar and special adhesive for high temperature surface.

5. The weight ratio of the mixed bonding mortar is water: mortar =1:5, and water is added while stirring; The mixing time shall not be less than 5min, and the mixing shall be sufficient and uniform, with moderate consistency and certain viscosity.

6. After the mortar is prepared, let it stand for 5 minutes, and stir it again before use. The mixed mortar should be used up within 1 hour.


thermal insulation board

www.suntherm-industry.com


Send Inquiry