Trim
1. Remove the ceramic fiber module strapping
After the ceramic fiber module lining construction of the entire heating furnace is completed, after confirming that it meets the design requirements, cut and remove the strapping, and take out the splint
2. The ceramic fiber module has a flat surface
Use a racket to level the surface of the lining, and then sweep the surface with a broom. To avoid too much dust in the air, spray water on the lining surface to moisten the surface before cleaning.
3. After leveling, trimming of ceramic fiber module
After the surface is leveled, if there is a through gap of more than 5mm between the joints of the ceramic fiber modules after inspection, the ceramic fiber folded carpet of the same temperature grade should be filled to close the joint gaps.
Repair
1.When there are pit-like damages on the surface of the ceramic fiber module, the ceramic fiber module should be repaired instead of trimming.
2. For the pit-shaped damaged ceramic fiber module that is less than one and a half-folded carpet width, use a sharp knife to remove one folded carpet piece by folding carpet piece. The removal range covers the entire pit-shaped damaged area, and the depth is approximately to the inside of the ceramic fiber module. The anchorage is then repaired with a folded carpet sheet of the same temperature level.
3. For the concave damaged ceramic fiber module that is larger than the width of the carpet, the whole piece should be dismantled, and the slider (sheet, plate) welded on the furnace wall or installed on the inner stud should be removed. For the lining structure without backing, the anchor stud of the MA module is welded at the center point of the original ceramic fiber module with a special welding machine.
www.suntherm-industry.com






