+86-533-6286577

Share Three Ways To Build Ceramic Fiber Module Furnace Lining

Dec 29, 2021

At present, the lining structure of ceramic fiber used in the heating furnace of oil refining and chemical equipment is mainly a composite structure composed of ceramic fiber modules and ceramic fiber backing. The formation process of the composite lining structure is: first, the furnace wall steel plate is cleaned and derusted; It is anti-corrosion treatment; third, the wire is laid out according to the design requirements, and the anchor nail position is determined to weld the anchor nail; fourth, the ceramic fiber blanket is laid as a backing; fifth, the ceramic fiber module is installed, and the center hole of the ceramic fiber module Align the welded anchor nails, use a special socket wrench to go deep into the module along the central hole of the ceramic fiber module and tighten the nut on the anchor nail; sixth, after all the ceramic fiber modules are installed, cut off the module Pack the straps and pull out the protective plate on the side of the module; finally, flatten the surface of the module to form.

There are two types of composite furnace lining structures composed of ceramic fiber modules and ceramic fiber backings, which are parquet and platoon. The parquet is the installation of adjacent ceramic fiber modules in a 90° staggered arrangement along the folding and compression direction. All installed After cutting the straps, the ceramic fiber modules expand and rebound in different directions to fill the gaps, and finally form. Due to the dimensional errors of the ceramic fiber modules and the uneven expansion of the corners, the corners between the modules are easy to form gaps. And become a dead point that is not easy to handle,

Therefore, the application of the parquet structure is relatively small. The platoon type is that the ceramic fiber modules are arranged in order according to the folding compression direction. The gap between the two rows of modules in the non-folding compression direction is filled with a folded and compressed ceramic fiber blanket to compensate Shrinkage: This structure is currently the most used.

                                                      www.suntherm-industry.com


Send Inquiry