+86-533-6286577

Application Of Ceramic Fiber Module In Heating Furnace

Dec 14, 2021

The application of ceramic fiber modules in the heating furnace has the functions of reducing the surface temperature of furnace parts, reducing fuel consumption, increasing output, reducing oxidation burning loss, and improving furnace life. details as follows:


1)  The surface temperature of the furnace body drops. In the case of normal heating production, the heat preservation and insulation conditions of the heating furnace were tested. The test parts were heating, soaking and furnace roof sections. The test results showed that the furnace wall without ceramic fiber modules showed that the temperature was 271.0 degrees on average. After application, the furnace wall shows an average temperature of 119.3 degrees, which reduces the surface heat dissipation of all parts of the furnace body.

 

2)  Reduced fuel consumption and increased output. The installation of the ceramic fiber module lining is carried out when the heating furnace is overhauled. The comparison over the same period shows that the cumulative gas consumption after the application of ceramic fiber module lining has decreased by 4.7%, while the amount of billets entering the furnace has increased by 6.09%, and the output of finished products has increased by 6.72%.

 ceramic fiber coating

3)  Reduction of oxidation burn loss. The ceramic fiber module is used as the furnace lining to improve the quality of steel burning, the heat sensitivity of the furnace is increased, and the heating speed is fast, so that the oxidation burning loss rate of the billet can be controlled at 1.55% to 1.65%, which is better than the heating furnace without the ceramic fiber module lining. The loss rate was reduced by 0.157%.

 

4)  The furnace life is extended. With ceramic fiber module lining, the side wall temperature is reduced by an average of 41 degrees, and the furnace top temperature is reduced by an average of 113.9 degrees, which delays the rapid heat and cold caused by direct flame erosion, thereby prolonging the service life of the furnace masonry.

                        www.suntherm-industry.com


Send Inquiry